DeWalt D55146 Bedienerhandbuch Seite 19

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 63
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 18
CODE
18 Extension cord is wrong length or gauge
20 Possible defective motor or starting capacitor
POSSIBLE CAUSE i POSSIBLE SOLUTION:
'Drain oiJ and refill pumP with DEWALT synthetic compressor
0il,
Check for proper gauge wire and cord length. See
Extension Cords under Installation.
COntact a DEWALT factory service Center a DEWALT
authorized service center.
Contact a DEWALT factory service center or a DEWALT
authorized service center.
21 Paint spiay 0n internal motor parts Contact a DEWALT faCt0rY Seivice Centei a DEWALT
I auth0rized Service Center. Do not operate the compressor in
the paint spray area. See flammaMe vapor warning.
22 Fuse blown, circuit breaker tripped 1. Check fuse box for blown fuse and replace as necessary.
I
23 Tank pressure exceeds pressure switch cut-in pressure
24 Pressure release valve on pressure switch has not
unloaded head pressure
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper extension
cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
i
i Motor will start automatically when tank pressure drops
below cut-in pressure of pressure switch!
Set the On/Off switch to OFE If the valve does not open,
replace switch. Contact a DEWALT factory service center or
a DEWALT authorized service center.
19
Seitenansicht 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 62 63

Kommentare zu diesen Handbüchern

Keine Kommentare