DeWalt DW9116 Betreibershandbuch

XRS-4 X-RAY SOURCE OPERATOR’S MANUAL

9 6.0 SOFTWARE The software program that controls the microcontroller can be identified by turning the key switch on while both push button switches

10 8.0 TROUBLESHOOTING SYMPTOM TEST ACTION No “power on” light -Check battery voltage -Check battery connection - Replace or charge battery - Make

11 BOARD INSTALLATION 1. Slide counter board back into the top of the Control Module housing just below the screw receptacles. 2. Push the counter

12 Figure 7:Oscillator Board Counter Board STEP 2 STEP 2 STEP 1 STEP

13 10.0 WARRANTY Golden Engineering, Inc. warrants XRS-4 X-ray unit made and sold by it or its authorized representatives to be free of defects in ma

14 11.0 SPECIFICATIONS PHYSICAL DIMENSIONS INCLUDING BATTERY PACK LENGTH 17.5 inches (44.5 cm) WIDTH 5 inches (13.5 cm) HEIGHT 8.5 inches (21.6 cm

- 1 - CONTENTS ITEM PAGE 1.0 INTRODUCTION...

1.0 INTRODUCTION The XRS-4 produces high levels of radiation and must be operated by qualified personnel who have read the Warning and Operations se

3 3.0 PHYSICAL DESCRIPTION Figure 1: XRS-4 X-ray Unit HIGH VOLTAGE PULSER/TUBEHEAD. The main body of the XRS-4 is the tube head which contains t

4 3.5 CONTROL MODULE Figure 3: Control Module POWER ON LIGHT: Illuminates when battery voltage is applied to control modu

5 XRS-4 REAR VIEW/CABLE CONNECTOR PIN # DESCRIPTION 1 +5 VOLTS 100 ma MAXIMUM 2 REMOTE SWITCH 3 REMOTE SWITCH – NO DEL

6 4.0 DESCRIPTION OF OPERATION The block diagram below illustrates how the XRS-4 functions. The following sequence of events takes place each

7 5.0 OPERATING INSTRUCTIONS OPERATING PRECAUTIONS: The operator should always stand at least 20 feet behind the X-ray unit and clear all personnel

8 DELAY MODE OPTION 1. Press Green DELAY BUTTON on top of the control module. 2. LCD displays 60 and X-ray begins 60 second time delay. 3. Hold