DeWalt DW621 Bedienerhandbuch PDF herunterladen (Seite 11)

Page 16

Note: Cross lines for locating and drilling holes are accurate. The illustration of subbase may vary

slightly in size and design, but is accurate enough for cutting the rubber spacer if required.

cut out and tape to top of side cover

align dotted line with edge of side cover

Drill hole to 1/2"

SIDE COVER DRILLING TEMPLATE

Refer to pages 4,5,6 before using template

Additional Templates Available on Website

Router Raizer Access Hole

3/4" reference circle for drilling the

routers original subbase only. Table

mounted, drill 1/2" hole in table top.

.500" reference circle

for drilling table top or

insert plate.

1/2" = .500

Use this 6" scale to check accuracy when copied

Sub-base mounting holes

Router table fence reference line

Drill .500" hole

through router

table insert plate

install #30 dust cover insert

into .500" hole and press flush

with top of insert plate

Router Raizer Access Hole

NOTE: This router requires a 3/4" pocket or a 3/4" hole through the

original subbase for router table installation. Pages 4,5,6

NOTE: This hole must be drilled 1/2" or .500"

for #30 dust cover insert to fit properly.

DeWalt 621

Router table mounting holes

1 2 ... 6 7 8 9 10 11

Keine Kommentare

DeWalt DW621 Bedienerhandbuch Seite 11