DeWalt DC987 Betriebsanleitung PDF herunterladen (Seite 12)

BAND-IT-IDEX, Inc.

A Unit of IDEX Corporation

4799 Dahlia Street

Denver, CO 80216-0307 USA

P: 1-800-525-0758

F: 1-800-624-3925

Document # P07886 Rev. L

BAND-IT-IDEX, Inc. 2010

www.BAND-IT-IDEX.com

Page 12 of 14

UL4000

Ultra-Lok



Tool

Maintenance

1. Approximately every 500 clamps, lubricate tension screw with

molybdenum disulfide lubricant, or equivalent.

Make sure tension block is all the way forward against the tool head. Remove

cap from syringe and insert tip of syringe into slot on top of tool body. Press

the tip against the tension screw just behind the tension block and squeeze

out approximately ½” long bead of lubricant. Remove syringe, and actuate

tool without a clamp a couple of times to spread lubricant evenly on tension

screw.

To order more lubricant, specify BAND-IT #C23199

3. To gain access to bearing components: remove blade mounting

screws (2 places) and slide blade free. Paper clip may be used to push

bearing components out of blade. Wipe lubricant from components. If ball or

bearing tips appears heavily worn, replace with new one. Note: ¼” ball is

made from hard tungsten carbide material, do not replace with regular ball

bearing. (Smooth indention from ball in the bearing tips is normal).

To re-assemble bearing components: wipe blade cavity clean. Push small

bearing tip into blade cavity. Apply lubricant to ball and push into blade cavity

and fill remaining space with lubricant. Push load bearing tip firmly into blade

cavity, some lubricant will be squeezed out. Re-attach blade to tool head,

making sure that load bearing tip extends into tension screw. While turning

blade mounting screws into blade, push on blade rearwards. Tighten screws

to approximately 120 in-lbs.

4. When replacing worn blade follow instructions above to properly

re-assemble bearing components.

2. Every 500-1000 clamps, depending on tension setting, inspect

and repack front bearing with same lubricant. Turn load bearing tip and

small bearing tip over for a new bearing surface.

Small Bearing Tip

Item 14

¼” Ball

Item 15

Load Bearing Tip

Item 16

Access Hole to push

out components (use

paper clip)

Blade

Item 2

Blade Cavity,

must be packed

with lubricant

Tension

Screw

Item 7

Bearing Detail

Blade Mounting

Screws

Item 22

Tool

Body

Tool

Head

Item 1

Lubricating

Syringe. Reorder

#C23199

1 2 ... 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

DeWalt DC987 Betriebsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Bohrmaschinen DeWalt DC987