DC920-XE, DC930-XE, DC940-XE HEAVY-DUTY XRP™ 13mm (1/2") CORDLESS DRILL/DRIVER DC925-XE, DC926-XE, DC935-XE, DC936-XE, DC945-XE HEAVY-DUTY XRP™ 1
8Three-Speed Gearing (Fig. 2)The three-speed feature of your tool allows you to shift gears for greater versatility. To select speed 1 (highest torque
9 3. Insert the accessory about 3/4" (19 mm) into the chuck and tighten securely by rotating the chuck sleeve clockwise with one hand while hol
10OPERATIONInstalling and Removing FIG. 9Gthe Battery Pack (Fig. 9)NOTE: Make sure your battery pack is fully charged. To install the battery pack in
11Cleaning WARNING: Blow dirt and dust out of all air vents with dry air at least once a week. To minimize the risk of eye injury, always wear ANSI Z8
12FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call (AUS) 1800 654 155 or (NZ) 09 259 1111 for a free repla
DEWALT Battery and Charger SystemsBattery Output Chargers/Charge TimeNominal 240 Volts 12 VoltsX Indicates that the battery pack is not compatible wi
1IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 259 1111 (NZ).SAFETY INSTRUCTIONS FOR POWE
2d. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may re
3Extension CordsCAUTION: Use only extension cords that are approved by the country’s Electrical Authority. Before using extension cords, inspect them
4DANGER: Electrocution Hazard. Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into c
5Important Safety Instructions for Battery ChargersSAVE THESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers.
6Using Automatic Tune-Up™ ModeThe Automatic Tune-Up™ Mode equalizes or balances the individual cells in the battery pack allowing it to function at pe
7NOTE: A battery pack will slowly lose its charge when kept out of the charger. If the battery pack has not been kept on maintenance charge, it may ne
Kommentare zu diesen Handbüchern