DeWalt DW933K Wartungshandbuch PDF herunterladen (Seite 26)

Do not cut materials that are thicker than

the maximum cutting depth.

• Use sharp saw blades only.

Damaged or bent saw blades must be

removed immediately.

• Never run your tool without a saw blade.

• For optimal results, move the tool

smoothly and constantly over the

workpiece. Do not exert lateral pressure

on the saw blade. Keep the shoe flat on

the workpiece. When sawing curves,

circles or other round shapes, push the

tool gently forward.

• Wait until the tool has come to a

standstill before removing the saw blade

from the workpiece. After sawing the

blade may be very hot. Do not touch.

Switching ON and OFF (fig. A)

For safety reasons your tool is equipped with a lock-

off button (2).

• Switching ON: press the lock-off button (2) to

unlock the tool and press the variable speed

switch (1). The sawing speed of the tool varies

with the pressure exerted on the variable speed

switch.

• Switching OFF: release the variable speed

switch (1).

After using the tool for an extended period

on low speed settings, run it for approx.

3 minutes on maximum no-load speed.

Sawing in wood

• If necessary, draw a cutting line.

• Switch the tool ON.

• Hold the tool against the workpiece and follow

the line.

• For sawing parallel to the edge of your

workpiece, install the parallel fence and guide

your jigsaw along the workpiece a shown in

figure G.

Sawing in wood using a pilot hole

• If necessary, draw a cutting line.

• Drill a hole (ø min. 12 mm) and introduce the saw

blade.

• Switch the tool on.

• Follow the line.

• For cutting perfectly round shapes, install the

trammel bar and set it to the required radius.

Sawing up to a projecting edge (fig. C)

• Remove the straight/round cut guide, if installed.

• Set the pendulum stroke selector to 0.

• Release the shoe lever (4).

• Push the shoe (5) all the way backward.

• Tighten the shoe lever (4).

• Switch the tool on.

Sawing in metal

• Mount an appropriate saw blade.

• Proceed as described above.

Use a cooling lubricant (cutting oil) to

prevent overheating of the saw blade or

the workpiece.

Sawing circles (fig. H)

• Install the trammel bar as shown.

Consult your dealer for further information on the

appropriate accessories.

Maintenance

Your DEWALT Power Tool has been designed to

operate over a long period of time with a minimum

of maintenance. Continuous satisfactory operation

depends upon proper tool care and regular cleaning.

Lubricating the guide roller (fig. I)

• Lubricate the guide roller (6) at regular intervals to

prevent jamming.

Cleaning

• Unplug the charger before cleaning the housing

with a soft cloth.

• Remove the battery pack before cleaning your

Power Tool.

• Keep the ventilation slots clear and regularly

clean the housing with a soft cloth.

ENGLISH

en - 6 21

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 103 104

Kommentare zu diesen Handbüchern

Keine Kommentare

DeWalt DW933K Wartungshandbuch Seite 26

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge DeWalt DW933K