DeWalt DC411 Bedienerhandbuch PDF herunterladen (Seite 23)

English

Mounting and Using Wire Brushes

and Wire Wheels

Wire cup brushes or wire wheels screw directly on the grinder

spindle without the use of flanges. Use only wire brushes or wheels

provided with a 5/8"-11 threaded hub. A Type 27 guard is required

when using wire brushes and wheels.

CAUTION: To reduce the risk of personal injury, wear work

gloves when handling wire brushes and wheels. They can

become sharp

CAUTION: To reduce the risk of damage to the tool, wheel or

brush must not touch guard when mounted or while in use.

Undetectable damage could occur to the accessory, causing wires

to fragment from accessory wheel or cup.

MOUNTING WIRE CUP BRUSHES AND WIRE WHEELS

WARNING: To reduce the risk of serious personal injury, turn

tool off and and remove battery pack before making any adjust-

ments or removing/installing attachments or accessories.

1. Thread the wheel on the spindle by hand.

2. Depress spindle lock button and use a wrench on the hub of the

wire wheel or brush to tighten the wheel.

3. To remove the wheel, reverse the above procedure.

CAUTION: To reduce the risk of damage to the tool, properly seat

the wheel hub before turning the tool on.

USING WIRE CUP BRUSHES AND WIRE WHEELS

Wire wheels and brushes can be used for removing rust, scale and

paint, and for smoothing irregular surfaces.

NOTE: The same precautions should be taken when wire brushing

paint as when sanding paint (see page 20).

1. Allow the tool to reach full speed before touching the tool to the

work surface.

2. Apply minimum pressure to work surface, allowing the tool to

operate at high speed. Material removal rate is greatest when

the tool operates at high speed.

3. Maintain a 5˚ to 10˚ angle between

5˚-10˚

the tool and work surface for wire cup

brushes.

4. Maintain contact between the edge of

the wheel and the work surface with

wire wheels.

5. Continuously move the tool in a forward and back motion to

avoid creating gouges in the work surface. Allowing the tool to

rest on the work surface without moving, or moving the tool in a

circular motion causes burning and swirling marks on the work

surface.

6. Remove the tool from the work surface before turning the tool

off. Allow the tool to stop rotating before setting it down.

CAUTION: Use extra care when working over an edge, as a

sudden sharp movement of grinder may be experienced.

Mounting and Using Cutting

(Type 1) Wheels

Cutting wheels include diamond wheels and abrasive discs.

Abrasive cutting wheels for metal and concrete use are available.

Diamond blades for concrete cutting can also be used.

WARNING: A closed, two-sided cutting wheel guard is included

with this tool and is re quired when using cutting wheels. Fail ure to

use proper flange and guard can re sult in injury resulting from

wheel breakage and wheel contact. See pages 14 and 15 for more

information.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

DeWalt DC411 Bedienerhandbuch Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge DeWalt DC411