DeWalt DC841 Betriebsanleitung PDF herunterladen (Seite 10)

Bevel Cutting

Lock the arm in the cross cutting position.

Raise the motor by rotating the elevation

crank. Release the bevel clamp and the

bevel index pin and tilt the motor in the

yoke. The bevel angle is shown on the bevel

scale. Release the bevel index pin and lock

the bevel clamp. Lower the arm into cutting

position. Adjust the arm stop to assure

clearance between blade and base. Pull the

saw through as you would for cross cutting.

Compound Miter Cutting

The compound miter is merely a combination of

the bevel cut and the miter cut. Set up the ma-

chine for bevel cutting. Release the arm clamp

handle and the miter latch handle. Move the

arm into the required position and lock the miter

latch and arm clamp. Adjust arm stop to assure

clearance between blade and base. Pull the

blade through as you would for cross cutting.

Bevel Ripping

Lock the arm in the cross cut position. Elevate the

motor. Rotate the yoke to the rip position and the

motor to the desired bevel position. Lock all latches

and clamps and tighten the rip lock. Adjust the

guard and anti-kickback as you would for the ripping

position. Always readjust as required. Use a push

board to feed the material into the blade; DO NOT

place hands between blade and guide fence. Do not

feed the material rapidly.

!!! DANGER !!!

!!! DANGER !!! !!! DANGER !!!

!!! DANGER !!!

NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT

NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT

NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

DeWalt DC841 Betriebsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kreissägen DeWalt DC841