DeWalt DC820 Bedienerhandbuch PDF herunterladen (Seite 11)

Forward/Reverse Control Button (Fig. 3)

A forward/reverse control button (C) determines the direction of the tool and also serves

as a lock off button. To select forward rotation, release the trigger switch and depress

the forward/reverse control button on the right side of the tool. To select reverse,

depress the forward/reverse control button on the left side of the tool. The center position

of the control button locks the tool in the OFF position. When changing the position of the

control button, be sure the trigger is released.

NOTE: The first time the tool is run after changing the direction of rotation, you may

hear a click on start up. This is normal and does not indicate a problem.

Worklight (Fig. 3)

There is a worklight (I) located just above the trigger switch (A). The worklight will be

activated when the trigger switch is squeezed.

NOTE: The worklight is for lighting the immediate work surface and is not intended to

be used as a flashlight.

Quick-Release Chuck (Fig. 4)

DC825-XE, DC827-XE, DC835-XE, DC845-XE

NOTE: The chuck accepts 6.35 mm (1/4") hex accessories only.

Place the switch in the locked off (center) position or remove battery pack before

changing accessories.

To install an accessory, pull the chuck collar (D) away from the front of the tool,

insert the accessory and release the collar. The accessory is locked in place.

To remove an accessory, pull the chuck collar away from the front of the tool.

Remove the accessory and release the collar.

FIG. 5

FIG. 4

FIG. 3

DW059

Variable Speed Trigger Switch (Fig. 3)

To turn the tool on, squeeze the trigger switch (A). To turn the tool off, release the

trigger switch. Your tool is equipped with a brake. The chuck will stop as soon as the

trigger switch is fully released. The variable speed switch enables you to select the

best speed for a particular application. The more you squeeze the trigger, the faster

the tool will operate. Use lower speeds for starting holes without a center punch,

drilling in metals or plastics, or driving screws. For maximum tool life, use variable

speed only for starting holes or fasteners.

NOTE: Continuous use in variable speed range is not recommended. It may damage

the switch and should be avoided.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

DeWalt DC820 Bedienerhandbuch Seite 11