DeWalt DCF681 Bedienerhandbuch PDF herunterladen (Seite 13)

FIG. 7

MAINTENANCE

ARNING: To reduce the risk of serious personal injury,

turn tool off and remove the battery pack before making any

adjustments or removing/installing attachments or accessories.

An accidental start-up can cause injury.

Cleaning

ARNING: Blow dirt and dust off of tool and cone/cutter area

(DCF681) with clean, dry air at least once a week. To minimize the

risk of eye injury, always wear ANSI Z87.1 approved eye protection

when performing this.

ARNING: Never use solvents or other harsh chemicals for

cleaning the non-metallic parts of the tool. These chemicals may

weaken the plastic materials used in these parts. Use a cloth

dampened only with water and mild soap. Never let any liquid get

inside the tool; never immerse any part of the tool into a liquid.

CHARGER CLEANING INSTRUCTIONS

ARNING: Shock hazard. Disconnect the charger from the AC

outlet before cleaning. Dirt and grease may be removed from the

exterior of the charger using a cloth or soft non-metallic brush. Do not

use water or any cleaning solutions.

DCF681

Insert the appropriate hex shank bit into the magnetic bit holder (G).

Refer to To Operate for instructions.

Operation as a Deburring T

ool (Fig. 2, 7)

DCF681

ARNING: Always keep hands and clothing away from the cutting

area of the tool.

ARNING: Only retract the cone by pressing against a pipe end.

Do not lock the cone in the retracted position.

NOTICE: When deburring it is recommended to leave a hex bit in the

magnetic holder. Metal chips and shavings caused by deburring can

be picked up by the magnet in the holder.

1. Activate the tool by the pressing the trigger and rotating the tool

in the desired direction.

2. Slowly feed into pipe and press cone against burred pipe end.

NOTE: Tool should be active before engaging with the pipe.

3. With tool activley rotating, firmly depress cone against the pipe,

engaging the cutter with pipe end. Allow multiple rotations to fully

deburr the pipe end.

WARNING: Tool can stall, causing a sudden twist. To reduce the

risk of injury, always use proper hand position as shown, and always

hold securely in anticipation of the tool cutter binding.

4. Once pipe end is deburred, pull the tool out of pipe and then

release the trigger.

ARNING: Before and after each use, inspect the cone for proper

closing. Do not operate the tool if the cone does not move freely and

close instantly.

1 2 ... 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

DeWalt DCF681 Bedienerhandbuch Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kraftschraubendreher DeWalt DCF681